Serial.print("Temperature: "); Serial.print(temp.temperature); Serial.println(" degC");
The I2C bus requires pull-up resistors on both the SDA and SCL lines to function properly. Place two 4.7kΩ resistors connected from the SDA and SCL lines up to the +5V power rail. mpu6050 library for proteus
Connect to power (Note: The real module operates at 2.375V-3.46V, but simulation often allows 5V). Serial
Click the button at the bottom left corner of Proteus to start your simulation session. mpu6050 library for proteus
Connect to a +5V power rail and GND to the ground terminal block. Wire the Virtual Terminal to view data: Connect Arduino TX (Pin 1) to Virtual Terminal RXD . Connect Arduino RX (Pin 0) to Virtual Terminal TXD . Step 4: Writing the Arduino Test Code