Smart Light Remote Controller Zh17 Manual Info

Within of the light turning on, repeatedly tap the currently assigned Channel Button in rapid succession.

Power is supplied by two AAA batteries (not included), accessible via a sliding rear panel. A low-battery warning is indicated by a double-blink of the red LED upon any button press. smart light remote controller zh17 manual

The light fixture will flash rapidly 5 to 6 times, confirming that the remote memory has cleared. 5. Advanced Features: Multi-Zone Grouping Within of the light turning on, repeatedly tap

The light will flash slowly nine times or revert to full default brightness to confirm it has unpaired from the controller. Method B: Manual Hardware Power Reset The light fixture will flash rapidly 5 to

Step 1: Physically isolate fixtures --> Unscrew Bulbs 5 through 8 from their sockets. Step 2: Initialize Zone 1 -----------> Turn on the wall switch and pair Bulbs 1–4 to Channel 1. Step 3: Power down and swap ---------> Turn off the switch. Re-install Bulbs 5–8 and unscrew Bulbs 1–4. Step 4: Initialize Zone 2 -----------> Turn on the switch and pair Bulbs 5–8 to Channel 2. Step 5: Consolidate configuration ---> Re-install all bulbs. They can now be controlled as separate zones. Unpairing and System Reset Procedures

Your ZH17 remote must link with the internal LED driver of your light fixture before it can transmit commands. Follow these steps to pair them: Standard Pairing Protocol: