Basic2nd-recovery-system.zip -24 6 Mb- ~upd~ -

: Must be formatted to FAT32 and be USB version 2.0 or lower .

The you are using to build the recovery drive basic2nd-recovery-system.zip -24 6 mb-

user wants a long article about the file "basic2nd-recovery-system.zip -24 6 mb-". The filename suggests a ZIP archive related to a recovery system, possibly for a BASIC computer, maybe the "Basic II" or "BASIC 2nd" edition for a computer like the Commodore 64, Commodore 128, or maybe the "BASIC 2nd" for the Sharp MZ series. The size is about 24.6 MB. : Must be formatted to FAT32 and be USB version 2

Find your panel's image file (typically found in your TIA Portal installation directory) and place it in the designated folder on the USB. Power Down: Completely switch off the HMI device. Insert USB: Plug the prepared drive into the panel's USB interface. Boot and Recover: Switch the power back on. The device should boot into a special recovery menu. "START RECOVERY" button three times as prompted by the interface to confirm. The size is about 24

Think of it as the “emergency boot disk” for Siemens HMI panels. While routine firmware updates and project downloads are typically handled by the TIA Portal software, this dedicated recovery tool is the last line of defense when:

A: No. It is highly unlikely to work. The bootloader inside the HMI screen was designed for USB 1.1/2.0 standards. The electrical signalling for USB 3.0 is often not recognized. Stick strictly to USB 2.0 or use an SD card adapter.

the contents of basic2nd-recovery-system.zip directly into the root directory of your formatted USB stick.