7004t-lm-v3 Password Reset !!top!! Page

Keep the pins bridged and plug in the power. Continue holding until you hear a beep (usually 5–10 seconds).

In the meantime, here’s a that works for many networking and embedded devices: 7004t-lm-v3 password reset

Release the short and wait for the system to reboot. The password should now be cleared or reset to the factory default ( admin with no password). 3. Software Recovery (Super Password) Keep the pins bridged and plug in the power

Completely disconnect the power supply from the DVR. The password should now be cleared or reset

Connect a console cable from your PC to the of the gateway. Open a terminal program like PuTTY on your PC.

After either reset method, the 7004t-lm-v3 falls back to its default network settings.

: Look for a set of three pins labeled JPW near the SATA connectors. Pin 1 : GND (Ground) Pin 2 : RESET Pin 3 : VCC