Move the helm slowly from hard-over port to hard-over starboard.
The ends with a brief checklist, but a proper sea trial is your final quality assurance. Here’s how to test: simrad rf300 installation manual
Select a dry, well-ventilated area protected from submersion. Move the helm slowly from hard-over port to
Align the unit so that its shaft is vertically parallel to the rudder stock axis. Align the unit so that its shaft is
Set the RF300 transmitter lever to its center position. You can use the alignment mark to line up the lever, which should be opposite the cable entry point.
Connect the transmitter rod to the ball joint at the rudder tiller arm. If the space is restricted, you may need to cut the transmitter rod to size.
Access the Installation Menu and select the RF300 as the source for rudder feedback.